Dust Collection - Grizzly G0962A40 Owner's Manual

32. Measure distance (A) from table edge to rear
end of fence rail brace, then adjust front end
of fence rail brace so it is the same distance
(B) from table edge (see Figure 32).
33. Secure front rail brace hex bolt from Step 30
with M8-1.25 hex nut (see Figure 32).
B
Figure 32. Fence rail brace installed.
34. Secure rear access panel and motor cover
each with (6) M5-.8 x 12 button head cap
screws (see Figure 33).
x 6
Figure 33. Rear access panel and motor cover
installed.
35. Install miter handle and 6 x 20mm flat washer
into miter gauge (see Figure 34).
Miter
Handle
Figure 34. Installing miter handle.
Model G0962A40 (Mfd. Since 07/22)
A
x 6
Miter
Gauge

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection system:
1.
Fit 4" dust hose over dust port and secure in
place with hose clamp (see Figure 35).
Figure 35. Dust hose attached to dust port.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
-27-