Dust Collection - Grizzly G0899 Owner's Manual

31. Attach a dust hose adapter to each end of
1 ⁄ " dust hose (see Figure 34).
1
2
Dust Hose
Adapters
Figure 34. Adapters attached to dust hose.
32. Slide one dust hose adapter onto 1
port (see Figure 35), until it fits snugly.
33. Attach 1
⁄ " dust hose to dust hose support
1
2
(see Figure 35), then insert dust hose adapt-
er into 1 ⁄ " dust port at rear of blade guard
1
2
assembly.
1 ⁄ " Dust Port
1
2
Blade
Guard
4" Dust
Port
Figure 35. Dust hose attached to saw, hose
support, and blade guard dust port.
34. Locate hole in cabinet near bottom left corner
of cabinet access door, then open door (see
Figure 36).
35. Remove (1)
⁄ "-20 hex nut and (1) 5mm flat
1
4
washer from push stick hangar (see Figure
36), then insert hangar into hole.
36. Thread (1)
⁄ "-20 hex nut with (1) 5mm flat
1
4
washer onto end of push stick hangar (see
Figure 36), then close door.
Model G0899 (Mfd. Since 10/20)
⁄ " dust
1
2
Hose Support
1 ⁄ "
1
2
Dust Port
Push Stick
Hangar
Figure 36. Push stick hangar installed.

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Minimum CFM at Dust Port: 500 CFM +
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Components Needed:
Dust Hose Adapters 1
1
Dust Hose 94" x 1 ⁄ " ..........................................1
1
2
Dust Hose 4 " (not included) ...............................1
Hose Clamps 4" (not included) ..........................2
Dust Collection System (not included) ...............1
Cabinet Access
Door
Qty
⁄ " ....................................2
2
-27-