Inventory - Grizzly G0555 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Shipping Inventory: (Figures 3–5)
A. Bandsaw Assembly .................................... 1
B. Upper Stand Braces................................... 2
C. Stand Top ................................................... 1
D. Miter Gauge Assembly ............................... 1
E. Stand Sides ................................................ 2
F.
Table w/Insert & Table Pin ......................... 1
G. Table Trunnion............................................ 1
H. Table Lock Knobs
I.
Lower Stand Braces ................................... 2
J.
Front Fence Rail......................................... 1
K. Rear Fence Rail ......................................... 1
L. Fence Assembly......................................... 1
M. Hardware (Not Shown):
—Hex Bolts M6-1 x 16 (Stand)................. 16
—Flat Washers 6mm (Stand)................... 16
—Flange Nuts M6-1 (Stand) .................... 16
—Stand Feet ⁄ "-16 x 2" (Stand)................ 4
3
8
—Hex Nuts ⁄ "-16 (Stand Feet).................. 8
3
8
—Flat Washers ⁄ " (Stand Feet) ................ 8
3
8
—Carriage Bolts M8-1.25 x 16 (Stand) ...... 8
—Flange Nuts M8-1.25 (Stand).................. 8
—Hex Bolts M8-1.25 x 35 (Bandsaw) ........ 4
—Flat Washers 8mm (Bandsaw) ............... 8
—Lock Washers 8mm (Bandsaw).............. 4
—Hex Nuts M8-1.25 (Bandsaw) ................. 4
—Hex Bolts M8-1.25 x 30 (Trunnion) ......... 2
—Lock Washers 8mm (Trunnion)............... 2
—Hex Bolt M8-1.25 x 80 (Positive Stop) .... 1
—Hex Nut M8-1.25 (Positive Stop)............. 1
—Fence Stand-Off M6-1 x 20 (Fence)....... 1
—Lock Handle M8-1.25 x 20 (Fence)......... 1
—Cap Screws M6-1 x 16 Black (Fence) .... 2
—Hex Bolts M6-1 x 20 Black (Fence) ........ 2
—Lock Washers 6mm Black (Fence)......... 2
—Flat Washers 6mm Black (Fence) .......... 2
—Hex Nut M8-1.25 Black (Fence).............. 1
—Hex Nut M6-1 Black (Fence)................... 1
Model G0555 (Mfd. Since 5/11)
Qty
⁄ "-16 ............................ 2
3
8
A
Figure 3. Bandsaw assembly.
C
D
F
G
H
Figure 4. Other components.
J K
Figure 5. Fence components.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
B
E
I
L
-13-