Publickey Authentication Enabled Stelnet Server Configuration Example - HPE FlexNetwork 10500 Series Security Configuration Manual

Figure 105 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system notifies you to enter the username and
password. After entering the username (client001 in this example) and password (aabbcc in
this example), you can enter the CLI of the server.
Publickey authentication enabled Stelnet server
configuration example
Network requirements
As shown in
and the RSA public key algorithm.
Establish an Stelnet connection between the host and the switch, so you can log in to the switch to
configure and manage the switch.
Figure 106 Network diagram
Stelnet client
192.168.1.56/24
Host
Figure 106, the switch acts as the Stelnet server, and it uses publickey authentication
Vlan-int2
192.168.1.40/24
Stelnet server
Switch
427