Password Authentication Enabled Stelnet Client Configuration Example - HPE FlexNetwork 10500 Series Security Configuration Manual

a. Click Open to connect to the server.
If the connection is successfully established, the system notifies you to enter the username.
After entering the username (client002), you can enter the CLI of the server.
Password authentication enabled Stelnet client configuration
example
Network requirements
As shown in
•
Switch B acts as the Stelnet server and uses password authentication.
•
The username and password of the client are saved on Switch B.
Establish an Stelnet connection between Switch A and Switch B, so you can log in to Switch B to
configure and manage Switch B.
Figure 113 Network diagram
Stelnet client
Vlan-int2
192.168.1.56/24
Switch A
Configuration procedure
1. Configure the Stelnet server:
# Generate RSA key pairs.
<SwitchB> system-view
[SwitchB] public-key local create rsa
The range of public key modulus is (512 ~ 2048).
If the key modulus is greater than 512, it will take a few minutes.
Press CTRL+C to abort.
Input the modulus length [default = 1024]:
Generating Keys...
........................++++++
...................++++++
..++++++++
............++++++++
Create the key pair successfully.
# Generate a DSA key pair.
[SwitchB] public-key local create dsa
The range of public key modulus is (512 ~ 2048).
If the key modulus is greater than 512, it will take a few minutes.
Press CTRL+C to abort.
Input the modulus length [default = 1024]:
Generating Keys...
.++++++++++++++++++++++++++++++++++++++++++++++++++*
........+......+.....+......................................+
...+.................+..........+...+
Create the key pair successfully.
Figure 113:
Vlan-int2
192.168.1.40/24
Stelnet server
Switch B
433