HPE FlexNetwork 10500 Series Security Configuration Manual page 239

IPv4:
Portal status: Enabled
Portal authentication method: Layer3
Portal web server: newpt
Authentication domain: Not configured
Pre-auth domain: Not configured
User-dhcp-only: Disabled
Pre-auth IP pool: Not configured
Max Portal users: Not configured
Bas-ip: 20.20.20.1
User Detection:
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Portal authentication method: Disabled
Portal web server: Not configured
Authentication domain: Not configured
Pre-auth domain: Not configured
User-dhcp-only: Disabled
Pre-auth IP pool: Not configured
Max Portal users: Not configured
Bas-ip: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
Before passing portal authentication, a user that uses the HPE iNode client can access only the
authentication page http://192.168.0.111:8080/portal. All Web requests from the user will be
redirected to the authentication page.
•
The user can access the resources permitted by ACL 3000 after passing only identity
authentication.
•
The user can access network resources permitted by ACL 3001 after passing both identity
authentication and security check.
# After the user passes identity authentication and security check, use the following command to
display information about the portal user.
[SwitchA] display portal user interface vlan-interface 4
Total portal users: 1
Not configured
Server name
--
Mask
Mask
Server name
--
222
Action
--
Action
--
Prefix length
Prefix length