HPE FlexNetwork 10500 Series Security Configuration Manual page 241

Configure portal authentication server detection, so that the switch can detect the

reachability of the portal authentication server by cooperating with the portal server
heartbeat function.
Configure portal user synchronization, so that the switch can synchronize portal user

information with the portal authentication server by cooperating with the portal user
heartbeat function.
Configuring the portal authentication server on IMC PLAT 5.0
In this example, the portal server runs on IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
1. Configure the portal authentication server:
a. Log in to IMC and click the Service tab.
b. Select User Access Manager > Portal Service Management > Server from the
navigation tree to open the portal server configuration page, as shown in
c. Configure the portal server heartbeat interval and user heartbeat interval.
d. Use the default settings for other parameters.
e. Click OK.
Figure 68 Portal authentication server configuration
2. Configure the IP address group:
a. Select User Access Manager > Portal Service Management > IP Group from the
navigation tree to open the portal IP address group configuration page.
b. Click Add to open the page as shown in
c. Enter the IP group name.
d. Enter the start IP address and end IP address of the IP group.
Make sure the host IP address is in the IP group.
e. Select a service group.
This example uses the default group Ungrouped.
f. Select the action Normal.
g. Click OK.
Figure 69.
224
Figure 68.