Portal Configuration Examples; Configuring Direct Portal Authentication - HPE FlexNetwork 10500 Series Security Configuration Manual
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Security command reference (881 pages) ,
- Network management and monitoring command reference (423 pages) ,
- Configuration manual (407 pages)
Table of Contents
Advertisement
Portal configuration examples
Configuring direct portal authentication
Network requirements
As shown in
assigned a public IP address either manually or through DHCP. A portal server acts as both a portal
authentication
authentication/accounting server.
Configure direct portal authentication, so the host can access only the portal server before passing
the authentication and access other network resources after passing the authentication.
Figure 56 Network diagram
Host
2.2.2.2/24
Gateway: 2.2.2.1/24
Configuration prerequisites
•
Configure IP addresses for the host, switch, and servers as shown in
they can reach each other.
•
Configure the RADIUS server correctly to provide authentication and accounting functions.
Configuring the portal authentication server on IMC PLAT 5.0
In this example, the portal server runs on IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
1.
Configure the portal authentication server:
a. Log in to IMC and click the Service tab.
b. Select User Access Manager > Portal Service Management > Server from the
navigation tree to open the portal server configuration page, as shown in
c. Configure the portal server parameters as needed.
This example uses the default settings.
d. Click OK.
Figure
56, the host is directly connected to the switch (the access device). The host is
server
and
a
Vlan-int100
Vlan-int2
2.2.2.1/24
192.168.0.100/24
Switch
portal
Web
server.
Portal server
192.168.0.111/24
RADIUS server
192.168.0.112/24
200
A
RADIUS
server
Figure 56
Figure
acts
as
the
and make sure
57.
Advertisement
Table of Contents
Troubleshooting
