Publickey Authentication Enabled Stelnet Server Configuration Example - HPE FlexFabric 7900 Series Security Configuration Manual

Figure 34 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username and
password. After entering the username (client001 in this example) and password (aabbcc in
this example), you can enter the CLI of the server.
Publickey authentication enabled Stelnet server
configuration example
Network requirements
As shown in
the RSA public key algorithm.
Establish an Stelnet connection between the host and the switch, so you can log in to the switch for
configuration management.
Figure 35 Network diagram
Stelnet client
192.168.1.56/24
Host
Figure 35, the switch acts as the Stelnet server, and it uses publickey authentication and
Vlan-int2
192.168.1.40/24
Stelnet server
Switch
159