HPE FlexNetwork 10500 Series Security Configuration Manual page 242

Figure 69 Adding an IP address group
3. Add a portal device:
a. Select User Access Manager > Portal Service Management > Device from the
navigation tree to open the portal device configuration page.
b. Click Add to open the page as shown in
c. Enter the device name NAS.
d. Enter the IP address of the switch's interface connected to the host.
e. Enter the key, which must be the same as that configured on the switch.
f. Set whether to enable IP address reallocation.
This example uses direct portal authentication, and therefore select No from the Reallocate
IP list.
g. Select whether to support server heartbeat and user heartbeat functions.
In this example, select Yes for both Support Server Heartbeat and Support User
Heartbeat.
h. Click OK.
Figure 70 Adding a portal device
4. Associate the portal device with the IP address group:
a. As shown in Figure
of device NAS to open the port group configuration page.
Figure
71, click the icon in the Port Group Information Management column
225
70.