Troubleshooting Port Security; Cannot Set The Port Security Mode - HPE FlexNetwork 10500 Series Security Configuration Manual

Authorization mode
Port access control
Multicast trigger
Mandatory auth domain
Guest VLAN
Auth-Fail VLAN
Critical VLAN
Critical voice VLAN
Add Guest VLAN delay
Re-auth server-unreachable : Logoff
Max online users
User IP freezing
Reauth period
Send Packets Without Tag
Max Attempts Fail Number
Guest VSI
Auth-Fail VSI
Critical VSI
Add Guest VSI delay
EAPOL packets: Tx 16331, Rx 102
Sent EAP Request/Identity packets : 16316
EAP Request/Challenge packets: 6
EAP Success packets: 4
EAP Failure packets: 5
Received EAPOL Start packets : 6
Online 802.1X users: 1
MAC address
0002-0000-0011
# Verify that frames with an unknown destination MAC address, multicast address, or broadcast
address are discarded. (Details not shown.)

Troubleshooting port security

Cannot set the port security mode

Symptom
Cannot set the port security mode for a port.
Analysis
For a port operating in a port security mode other than noRestrictions, you cannot change the port
security mode by using the port-security port-mode command.
: Auto
: MAC-based
: Enabled
: sun
: Not configured
: Not configured
: Not configured
: Disabled
: Disabled
: 4294967295
: Disabled
: 0 s
: Disabled
: 0
: Not configured
: Not configured
: Not configured
: Disabled
EAPOL LogOff packets: 2
EAP Response/Identity packets : 80
EAP Response/Challenge packets: 6
Error packets: 0
Auth state
Authenticated
263