Configuration Task List; Enabling Mac Authentication - HPE FlexNetwork 10500 Series Security Configuration Manual
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Security command reference (881 pages) ,
- Network management and monitoring command reference (423 pages) ,
- Configuration manual (407 pages)
Table of Contents
Advertisement
•
To ensure successful MAC authentication, do not configure both the VSI assignment feature
and the feature of including user IP addresses in MAC authentication requests on a port.
•
Do not delete a Layer 2 aggregate interface if the interface has online MAC authentication
users.
•
Do not configure both MAC authentication and VLAN mapping on the same port. For
information about VLAN mapping, see Layer 2—LAN Switching Configuration Guide.
Configuration task list
Tasks at a glance
(Required.)
(Optional.)
Specifying a MAC authentication domain
(Optional.)
Configuring the user account format
(Optional.)
Configuring MAC authentication timers
(Optional.)
Setting the maximum number of concurrent MAC authentication users on a port
(Optional.)
Enabling MAC authentication multi-VLAN mode on a port
(Optional.)
Configuring MAC authentication delay
(Optional.)
Enabling parallel processing of MAC authentication and 802.1X authentication
(Optional.)
Configuring a MAC authentication guest VLAN
(Optional.)
Configuring a MAC authentication critical VLAN
(Optional.)
Enabling the MAC authentication critical voice VLAN
(Optional.)
Configuring a MAC authentication guest VSI
(Optional.)
Configuring a MAC authentication critical VSI
(Optional.)
Configuring periodic MAC reauthentication
(Optional.)
Including user IP addresses in MAC authentication requests
(Optional.)
Enabling MAC authentication offline detection
(Optional.)
Enabling logging for MAC authentication users
Enabling MAC authentication
For MAC authentication to take effect on a port, you must enable this feature globally and on the port.
Do not enable MAC authentication on a port that is in a service loopback group.
To enable MAC authentication:
Step
1.
Enter system view.
2.
Enable MAC authentication
globally.
3.
Enter interface view.
Enabling MAC authentication
Command
system-view
mac-authentication
interface interface-type
interface-number
145
Remarks
N/A
By default, MAC authentication
is disabled globally.
N/A
Advertisement
Table of Contents
Troubleshooting
