HPE FlexNetwork 10500 Series Security Configuration Manual page 551
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Security command reference (881 pages) ,
- Network management and monitoring command reference (423 pages) ,
- Configuration manual (407 pages)
Table of Contents
Advertisement
Figure 143 Network diagram
Device A
ND snooping
Device B
GE1/01
Host A
10::5/64
0001-0203-0405
Configuration procedure
1.
Configure Device A:
# Create VLAN 10.
<DeviceA> system-view
[DeviceA] vlan 10
[DeviceA-vlan10] quit
# Configure GigabitEthernet 1/0/3 to trunk VLAN 10.
[DeviceA] interface gigabitethernet 1/0/3
[DeviceA-GigabitEthernet1/0/3] port link-type trunk
[DeviceA-GigabitEthernet1/0/3] port trunk permit vlan 10
[DeviceA-GigabitEthernet1/0/3] quit
# Assign IPv6 address 10::1/64 to VLAN-interface 10.
[DeviceA] interface vlan-interface 10
[DeviceA-Vlan-interface10] ipv6 address 10::1/64
[DeviceA-Vlan-interface10] quit
2.
Configure Device B:
# Create VLAN 10.
<DeviceB> system-view
[DeviceB] vlan 10
[DeviceB-vlan10] quit
# Configure GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 to trunk
VLAN 10.
[DeviceB] interface gigabitethernet 1/0/1
[DeviceB-GigabitEthernet1/0/1] port link-type access
[DeviceB-GigabitEthernet1/0/1] port access vlan 10
[DeviceB-GigabitEthernet1/0/1] quit
Internet
Gateway
GE1/0/3
Vlan-int10
10::1/64
VLAN 10
GE1/0/3
GE1/0/2
Host B
10::6/64
0001-0203-0607
534
Advertisement
Table of Contents
Troubleshooting
