Configuring Snmp Notifications For Ike; Displaying And Maintaining Ike - HPE FlexNetwork 10500 Series Security Configuration Manual

Step
2. Configure an IKE IPv4
address pool.

Configuring SNMP notifications for IKE

After you enable SNMP notifications for IKE, the IKE module notifies the NMS of important module
events. The notifications are sent to the device's SNMP module. You can configure the notification
transmission parameters for the SNMP module to specify how the SNMP module displays
notifications. For more information about SNMP notifications, see Network Management and
Monitoring Configuration Guide.
To generate and output SNMP notifications for a specific IKE failure or event type, perform the
following tasks:
1. Enable SNMP notifications for IKE globally.
2. Enable SNMP notifications for the failure or event type.
To configure SNMP notifications for IKE:
Step
1. Enter system view
2. Enable SNMP
notifications for IKE
globally.
3. Enable SNMP
notifications for the
specified failure or
event types.

Displaying and maintaining IKE

Execute display commands in any view and reset commands in user view.
Task
Display configuration information about all IKE
proposals.
Display information about the current IKE SAs.
Display IKE statistics.
Delete IKE SAs.
Clear IKE MIB statistics.
Command
ike address-group
group-name start-ipv4-address
end-ipv4-address [ mask |
mask-length ]
Command
system-view
snmp-agent trap enable ike global
snmp-agent trap enable ike
[ attr-not-support | auth-failure |
cert-type-unsupport | cert-unavailable |
decrypt-failure | encrypt-failure |
invalid-cert-auth | invalid-cookie |
invalid-id | invalid-proposal |
invalid-protocol | invalid-sign |
no-sa-failure | proposal-add | proposal–
delete | tunnel-start | tunnel-stop |
unsupport-exch-type ] *
Command
display ike proposal
display ike sa [ verbose [ connection-id
connection-id | remote-address [ ipv6 ]
remote-address [ vpn-instance
vpn-instance-name ] ] ]
display ike statistics
reset ike sa [ connection-id connection-id ]
reset ike statistics
368
Remarks
By default, no IKE IPv4 address
pool exists.
Remarks
N/A
By default, SNMP notifications
for IKE are enabled.
By default, SNMP notifications
for all failure and event types
are enabled.