Web Authentication Using The Radius Authentication Server - HPE FlexNetwork 10500 Series Security Configuration Manual

[Device] web-auth server user
# Configure the redirection URL for the Web authentication server as http://20.20.0.1/portal/.
[Device-web-auth-server-user] url http://20.20.0.1/portal/
# Specify 20.20.0.1 as the IP address and 80 as the port number for the Web authentication
server.
[Device-web-auth-server-user] ip 20.20.0.1 port 80
[Device-web-auth-server-user] quit
# Specify ISP domain local as the Web authentication domain.
[Device] interface gigabitethernet 1/0/1
[Device-GigabitEthernet1/0/1] web-auth domain local
# Enable Web authentication by using Web authentication server user.
[Device-GigabitEthernet1/0/1] web-auth enable apply server user
[Device-GigabitEthernet1/0/1] quit
Verifying the configuration
# Display online Web authentication user information after user localuser passes Web
authentication.
<Device> display web-auth user
Total online web-auth users: 1
User Name: localuser
MAC address: acf1-df6c-f9ad
Access interface: GigabitEthernet1/0/1
Initial VLAN: 1
Authorization VLAN: N/A
Authorization ACL ID: N/A
Authorization user profile: N/A

Web authentication using the RADIUS authentication server

Network requirements
As shown in
Configure Web authentication to meet the following requirements:
•
The device performs Web authentication for users by using a RADIUS server.
•
The device pushes customized Web authentication pages to users and use HTTP to transfer
the authentication data.
Figure 167, the host is connected to the device through GigabitEthernet 1/0/1.
601