Static Ipv6Sg Configuration Example - HPE FlexNetwork 10500 Series Security Configuration Manual

Figure 132 Network diagram
DHCP client
Host
MAC: 0001-0203-0406
Configuration procedure
1. Configure dynamic IPv4SG:
# Configure IP addresses for the interfaces. (Details not shown.)
# Enable IPv4SG on VLAN-interface 100 and verify the source IP address and MAC address for
dynamic IPSG.
<Switch> system-view
[Switch] interface vlan-interface 100
[Switch-Vlan-interface100] ip verify source ip-address mac-address
[Switch-Vlan-interface100] quit
2. Configure the DHCP relay agent:
# Enable the DHCP service.
[Switch] dhcp enable
# Enable recording DHCP relay entries.
[Switch] dhcp relay client-information record
# Configure VLAN-interface 100 to operate in DHCP relay mode.
[Switch] interface vlan-interface 100
[Switch-Vlan-interface100] dhcp select relay
# Specify the IP address of the DHCP server.
[Switch-Vlan-interface100] dhcp relay server-address 10.1.1.1
[Switch-Vlan-interface100] quit
Verifying the configuration
# Verify that a dynamic IPv4SG binding is generated based on a DHCP relay entry.
[Switch] display ip source binding dhcp-relay
Total entries found: 1
IP Address
192.168.0.1

Static IPv6SG configuration example

Network requirements
As shown in
allow only IPv6 packets from the host to pass.
Figure 133 Network diagram
Host
IP: 2001::1
MAC: 0001-0202-0202
DHCP relay agent
Vlan-int100
Switch
MAC Address
0001-0203-0406 Vlan100
Figure 133, configure a static IPv6SG binding on GigabitEthernet 1/0/1 of the device to
GE1/0/1
Device
DHCP server
Vlan-int200
10.1.1.1/24
Interface
Internet
506
VLAN Type
100 DHCP relay