Safety - Sim2 AR User Manual

Information contained in this User Guide may be updated from time to time due to product im-
provements and customer feedback. Visit
ment.
This document contains proprietary information protected by copyright. All rights are reserved.
All trademarks and registered trademarks are the property of their respective owners.
2.

Safety

If the lamp suddenly explodes with a loud bang, turn off the projector immediately and air the
room thoroughly. Do not attempt to restart the projector and do attempt to replace the bulb:
contact your local service center.
Read this manual
Read all chapters of this manual carefully before switching on the projector. This manual provi-
des basic instructions for operating the AR projector. Installation, preliminary adjustments and
procedures that necessitate the removal of the top cover and contact with electrical componen-
ts must be performed by authorized, trained technicians. To ensure safe operation and long
term reliability use only the power cords supplied by the manufacturer. Observe all warnings
and precautions. Keep the manual for future consultation.
Do not touch internal parts of the projector
Inside the housing there are electrical parts carrying dangerously high voltages and parts opera-
ting at high temperature. Never open the housing. Entrust all servicing and repair work to a
SIM2 Authorized Service Center. Opening the housing voids the warranty.
Disconnect the appliance from the power supply
The device that disconnects the projector from the mains is the power plug. Ensure that the po -
wer cord plugs and the electrical outlets are easily accessible during installation operations. Pull
the plug, not the cord, to disconnect the projector from the mains. Use only the specified power
supply. Connect the projector to a mains electrical supply with rated voltage of between 100-
240 V AC, 50/60 Hz and equipped with a protective earth connection. If you are not sure of your
domestic mains rating, contact an electrician. Take care to avoid overloading the power socket
and any extension leads.
Switching the projector off
Pay attention to the switch off procedure for the projector. The projector must always be
brought back to the standby state to allow the projector to carry out the cooling procedure.
Should this not happen, for example due to a power cut, the projector may enter a state of pro -
tection that leads to switch-on being blocked. This block will last until the internal components
of the projector have completely cooled down.
Changing the fuses
Before changing the fuse, disconnect the projector from the mains power supply. The fuse com-
partment is next to the power supply connector. Remove the fuse holder with a flat head screw -
driver and replace the fuse. Fit the replacement fuse. Use only type T 10 A L H fuses for the pro -
jector.
Be careful with cables
Make sure cables are routed so that people are not impeded or become a trip hazard. Keep all
cables away from children. Install the projector as close to the wall socket as possible. Avoid
stepping on power cords, make certain they do not become tangled, and never jerk or tug them;
do not expose them to sources of heat, and make sure they do not become knotted or crimped.
If the power cords become damaged, stop using the projector and request the assistance of an
SIM2 BV International s.r.l
To reduce the risk of electrocution, disconnect the power cord on the
rear panel before removing the top cover of the projector. For technical
service refer to trained personnel authorized by the manufacturer.
www.sim2.com to find the latest version of this docu-
AR User Guide 4