Important Information; About This User Guide; Safety - Sim2 Sirio User Manual

1 Important information

About this User Guide

This User Guide describes how to set up and operate the following projector:
•SIRIO
Information contained in this User Guide may be updated from time to time due to
product improvements and customer feedback. Visit
version of this document.
This document contains proprietary information protected by copyright. All rights are
reserved.
All trademarks and registered trademarks are the property of their respective owners.

Safety

If the lamp suddenly explodes with a loud bang, turn off the projector immediately
and air the room thoroughly. Do not attempt to restart the projector and do attempt
to replace the bulb: contact your local service center.
Read this guide
Read all chapters of this guide carefully before switching on the projector. This guide
provides basic instructions for operating the SIRIO projector. Installation, preliminary
adjustments and procedures that necessitate the removal of the top cover and
contact with electrical components must be performed by authorized, trained
technicians. To ensure safe operation and long term reliability use only the power
cords supplied by the manufacturer. Observe all warnings and precautions. Keep this
guide for future consultation.
Do not touch internal parts of the projector
Inside the housing there are electrical parts carrying dangerously high voltages and
parts operating at high temperature. Never open the housing. Entrust all servicing and
repair work to a SIM2 Authorized Service Center. Opening the housing voids the
warranty.
Disconnect the appliance from the power supply
The device that disconnects the projector from the mains is the power plug. Ensure
that the power cord plugs and the electrical outlets are easily accessible during
installation operations. Pull the plug, not the cord, to disconnect the projector from
the mains. Use only the specified power supply. Connect the projector to a mains
electrical supply with rated voltage of between 100-240 V AC, 50/60 Hz and equipped
with a protective earth connection. If you are not sure of your domestic mains rating,
1 Important information
To reduce the risk of electrocution, disconnect the power cord on the
rear panel before removing the top cover of the projector. For technical
service refer to trained personnel authorized by the manufacturer.
www.sim2.com to find the latest
SIRIO
User Guide
3