Notice - Sim2 AR User Manual

Waste electrical and electronic materials (WEEE) should never be disposed of in normal urban
waste disposal facilities.
Observe the following instructions:
When you no longer wish to use your electrical and electronic equipment, take it to your
•
local waste disposal facility for recycling.
You may return your old equipment to your SIM2 Authorized Dealer free of charge when
•
you buy a new product that is equivalent or has the same functions as the old one. Con-
tact SIM2 to find your local dealer.
If you need more information regarding recycling, reuse and product exchanges, contact
•
SIM2 customer service.
Lastly we suggest further measures to safeguard the environment, such as recycling of internal
and external packaging (including that used for shipping) in which the product was delivered.
With your help, we can reduce the amount of environmental resources required to make electric
and electronic equipment, reduce the use of waste tips for used equipment and, in general, im -
prove our quality of life by making sure that hazardous materials are correctly scrapped. Incor-
rect treatment of the product at the end of its service life and failure to follow the above dispo -
sal instructions are punishable under local legislation.
Product disposal

Notice

The appliance has been subjected to exhaustive operating tests by SIM2 to guarantee the highe -
st quality. The projector bulb life should thus initially be around 30-60 hours. In addition to the
customary checks, the Quality Control department also runs additional statistical tests before
shipment. In such cases, the packaging may show signs of having been opened, and the hours of
lamp operation may prove to be higher than those normally shown when only standard tests are
performed.
As the optical system of the AR is extremely compact and has the purpose of developing very
high brightness and contrast, it is possible that a small quantity of light is visible outside of the
projection area and will vary depending on the type of lens used and the zoom and shift setup.
This characteristic of the optical system is to be deemed as normal. In order to reduce this effect
SIM2 recommends that the area surrounding the projection screen is as dark as possible.
The AR is a three chip DLP projector and uses three high resolution DMD (red, green, blue). The -
se three DMD are precisely aligned through a high precision process that reduces the alignment
error to within the foreseen limits of tolerance. The maximum limits of misalignment are the fol-
lowing:
Screen Center: up to 0.7 pixels between each color
•
Screen Borders: up to 2 pixels between each color
•
These limits are perfectly normal for this optical system and will not be considered as a malfunc -
tion of the product.
Note: One pixel corresponds to 10 thousandths of a millimeter on the DMD.
SIM2 BV International s.r.l
The label on the product, shown here, indicating a canceled garbage can,
is intended to remind you that the product requires special handling at
the end of its service life. Materials such as glass, plastic and some che-
mical compounds are recoverable and can be recycled for reuse.
The lamp inside this projector contains mercury and may be subject to
special disposal or recycle regulations. Dispose or recycle in accordance
with local laws. For more information contact the Electronic Industries
Alliance at www.eiae.org or check www.lamprecycle.org
AR User Guide 6