Kubota B1830 Workshop Manual page 54

B1830,B2230,B2530,B3030, WSM
Checking Parking Brake Lever Travel
1. Pull the parking brake lever (1) to the parking position while
counting the ratchet sound made by the parking brake lever (1).
2. If the counted ratchet sound is not within the factory
specification, adjust the parking brake lever travel.
CAUTION
• Stop the engine and remove the key, and the chock wheels
before checking parking brake.
Parking brake lever
Factory specification
travel
(When adjusting)
1. Release the parking brake lever.
2. Be sure to adjust the free travel of the right and left brake
pedals.
3. Place the jack under the transmission case, then remove the
rear tires and set the rigid rack under the rear axles.
4. Loosen the lock nuts (2) of the right and left rods (6).
5. Tighten the adjusting nut (3) of the right rod (6) by hand until the
collar (4) comes into contact with the arm (5). Make half and one
more turn of the nut.
6. Tighten the adjusting nut (3) of the left rod (6) by hand until the
collar (4) comes into contact with the arm (5).
7. Tighten up the lock nuts (2) of right and left rods.
8. Make sure the parking brake lever gets locked at the its 4th or
5th notch.
9. Install the right and left tires.
NOTE
• After adjusting the parking brake lever free travel:
– Right and left parking brake for even braking.
– With the parking brake released, make sure that the
right and left tires do not drag on.
(1) Parking Brake Lever
(2) Lock Nut
(3) Adjusting Nut
(4) Collar
(5) Parking Brake Arm
(6) Parking Brake Rod
Checking Fuel Line
1. Check to see that all lines and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
NOTE
• If the fuel line is removed, be sure to properly bleed the fuel
system. (See "Bleeding Fuel System" in as required
maintenance.)
(1) Fuel Line
G-29
GENERAL
4 to 5 notches
a: B3030HD (Serial No. 90000 and
below), B2530HD (Serial No.
90000 and below), B2530D (Serial
No. 50000 and below), B2230HD
(Serial No. 90000 and below),
B2230D (Serial No. 50000 and
below), B1830D (Serial No. 50000
and below)
b: B3030HD (Serial No. 90001 and
above), B2530HD (Serial No.
90001 and above), B2530D (Serial
No. 50001 and above), B2230HD
(Serial No. 90001 and above),
B2230D (Serial No. 50001 and
above), B1830D (Serial No. 50001
and above)
9Y1210003GEG0026US0
(2) Clamp Band
9Y1210003GEG0027US0
KiSC issued 05, 2012 A