Power Steering Cylinder - Kubota B2301 Workshop Manual

B2301, B2601, WSM

(3) Power Steering Cylinder

Front Wheels
• See page 5-S5.
Tie-rod Joint
1. Remove the slotted nut (4) and remove the tie-rod end (3).
2. Remove the front axle brackets (1), (2).
(When reassembling)
• Apply grease to the thrust collar of front axle bracket.
• Apply grease to the O-ring and be careful not to damage it.
• After tightening the slotted nut, install cotter pin as shown in the
figure.
(Bleeding air in power steering circuit)
• Start the engine.
• Turn the steering wheel slowly in both directions all the way
alternately several times, and stop the engine.
Tie-rod slotted nut
Tightening torque
Tie-rod joint
(1) Front Axle Bracket (Front)
(2) Front Axle Bracket (Rear)
(3) Tie-rod End
6-S7
STEERING
9Y1211156STS0009US0
18 to 35 N·m
1.9 to 3.5 kgf·m
14 to 25 lbf·ft
74 to 84 N·m
7.6 to 8.5 kgf·m
55 to 61 lbf·ft
(4) Slotted Nut
(5) Cotter Pin
9Y1211156STS0010US0
KiSC issued 11, 2014 A