Removing Receiver And Condenser - Kubota B1830 Workshop Manual

B1830,B2230,B2530,B3030, WSM

(3) Removing Receiver and Condenser

Stator
1. Remove the lead wire from compressor body.
2. Remove the external circlip (1).
3. Remove the stator (2).
(When reassembling)
• Do not use the cir-clip again.
• Assemble the cir-clip for the tapered side to become outside of
front housing.
• The width of expanding of cir-clip is set is boss of shaft as a
minimum.
• Match and assemble the concave part (3) of the front housing
(5) and the pin (4) of stator.
(Reference)
• Code No. for circlip: T1065-87440
(1) External Circlip
(2) Stator
(3) Concave Part
Removing Outer Roof
1. Remove the bolts (1), (2), (4).
2. Remove the outer roof (3).
Tightening torque Outer roof mounting screw
(1) Bolt
(2) Bolt
10-S34
(4) Pin
(5) Front Housing
9Y1210003CAS0061US0
3.5 to 4.0 N·m
0.36 to 0.40 kgf·m
2.6 to 2.9 lbf·ft
(3) Outer Roof
(4) Bolt
9Y1210003CAS0062US0
KiSC issued 05, 2012 A
CABIN