Kubota B1830 Workshop Manual page 40

B1830,B2230,B2530,B3030, WSM
Replacing Transmission Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the oil filters.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Drain the transmission fluid.
2. Remove the both oil filter cartridges by using a filter wrench.
3. Apply a slight coat of oil onto the new cartridge gasket.
4. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
5. After the new cartridge has been replaced, the transmission
fluid level will normally decrease slightly. Make sure that the
transmission fluid does not leak through the seal. Check the
fluid level.
IMPORTANT
• To prevent serious damage to the hydraulic system. Use
only a genuine KUBOTA filter or its equivalents.
(1) Hydraulic Oil Filter Cartridge
(for HST)
G-15
GENERAL
(2) Hydraulic Oil Filter Cartridge
9Y1210003GEG0010US0
KiSC issued 05, 2012 A