Separating Engine And Front Case From Tractor - Kubota B1830 Workshop Manual

B1830,B2230,B2530,B3030, WSM

(3) Separating Engine and Front Case from Tractor

Removing Center Pillar, Fuel Tank and Steering Post Assembly
1. Remove the center pillar (1).
2. Remove the fuel tank (2) and shutter plate.
3. Disconnect the power steering hoses and pipes.
4. Remove the steering post assembly (3).
(1) Center Pillar
(2) Fuel Tank
Draining Transmission Fluid
CAUTION
• Stop the engine before checking and changing the
transmission fluid.
1. Place the oil pan under the tractor.
2. Remove the drain plugs (1), (3), (5) at the mid-PTO shaft and at
the bottom of the rear axle cases (4), (6).
3. Drain the transmission fluid.
4. After draining the transmission fluid, reinstall the drain plugs (1),
(3), (5).
IMPORTANT
• Use only KUBOTA UDT oil. Use of other oils may damage
the transmission or hydraulic system.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8.
• Never work the tractor immediately after changing the
transmission oil. Keep the engine at medium speed for a
few minutes to prevents damage to the transmission.
• Do not mix different brands oil together.
B1830, B2230, B2530
Manual transmission
(without Bi-Speed
Turn)
B1830, B2230, B2530
Manual transmission
Transmission fluid
(with Bi-Speed Turn)
capacity
B1830HST,
B2230HST,
B2530HST
B3030 HST
(1) Drain Plug
(2) Mid-PTO Shaft
(3) Drain Plug
3-S24
TRANSMISSION
(3) Steering Post Assembly
9Y1210003TRS0024US0
15 L
4.0 U.S.gals
3.3 Imp.gals
16.5 L
4.4 U.S.gals
3.6 Imp.gals
17 L
4.5 U.S.gals
3.7 Imp.gals
17 L
4.5 U.S.gals
3.7 Imp.gals
(4) Rear Axle Case (L.H.)
(5) Drain Plug
(6) Rear Axle Case (R.H.)
9Y1210003TRS0025US0
KiSC issued 05, 2012 A