Program 30: Messages & Prompts Program; Programming The Preamble Or Postamble - Panasonic 5000 Series Operating Instructions Manual

MANAGER PROGRAMS
Program 30: Messages & Prompts Program
Program 30 gives you access to two types of messages: Preamble/Logo & Postamble and
the Prompts & Error Messages. Refer to the description for the type of message you want
to modify.

Programming the Preamble or Postamble

The preamble is a three-line message that appears at the top of your reports and
customer receipts. The postamble is the trailer message that prints at the bottom of the
receipts and reports. Use the following procedure to program these messages.
1. With the keylock in MGR position, use this sequence to advance to the Messages
program.
5
2. Go to the address that corresponds to the line you are programming. A general
description for each of the addresses is provided below.
[ address # ]
Postamble Line
Line 1
Line 2
Line 3
3. Place the alpha overlay on the keyboard and enter the new logo or postamble
message.
RCPT
STOP
5-36
CASH 3
CSHR
Addresses
= 200, 201
= 202, 203
= 204, 205
[ 1-16 character description ]
0
Preamble Line
Line 1 = 206, 207
Line 2 = 208, 209
Line 3 = 210, 211
Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
Messages & Prompts Program
CASH
Addresses
CASH