Panasonic 5000 Series Operating Instructions Manual page 179

Reports
Storewide Z1 Reports
There are two categories of Z1 reports you can take on a system-wide basis: Accumulation
Reports and Summary Reports. Accumulation Z1 Reports reset the report totals in all
basic workstations, and then store the consolidated totals in the Master. Summary
Reports reset all totals as the consolidated totals print. Usually you enter these report
procedures at the System Master.
1. Turn the keylock to MGR Mode. Use the following sequence to advance to the
Storewide Z1 Report menu.
2
2. To take an Accumulation Report, go to Step 3. For a Summary Report, enter '1'.
Then enter the number of the report you need to reset and press CASH. You must
use two digits for the report number. For example, if you are resetting a Summary
Media Report, you would enter 101 CASH.
Note:
3. If you used Step 2 to take a Summary Z1 Report, skip this step and go to Step 4.
To take a Z1 Accumulation Report, simply enter the number of the report you need
and press CASH. The workstation where you initiate the report collects the
consolidated report totals. The totals in all other workstations are reset.
Note:
4. When the report is finished, press CASH to leave the menu.
Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
CASH
[ 2-digit report # ]
1
In most cases, the report begins immediately. If additional information is
needed, follow the screen instructions. With a Summary Z1 Report, daily
totals reset as they print.
[ report # ]
Not all reports listed on the Z1 Menu can be accumulated. Refer to the
Report Summary Chart for a list of applicable Accumulation Reports.
CASH
3 0
CASH
MANAGER OPERATIONS
CASH
CASH
4-63