Panasonic 5000 Series Operating Instructions Manual page 176

MANAGER OPERATIONS
Terminal X2 Reports
Use the following steps to take a reading of the period-to-date (PTD) totals. PTD totals
are updated whenever you perform a System Open. Because System Open is taken at the
System Master, your PTD totals should all reside within the System Master. Under
normal circumstances, you use the following procedure at the System Master.
Note:
1. Turn the keylock at the System Master to MGR Mode.
2. Enter the following sequence to advance to the X2 Report menu.
3
Note:
1 Media
2 Time
3 Subgroup
4 All PLUs
5 All Cashiers
6 Coupons
3. Enter the number of the period report you want to read. In most instances, the
report starts immediately after you press CASH. If additional information is
needed, the screen waits until you enter the needed data (server number, PLU
number, etc.).
4. Press CASH when you are ready to leave this menu.
4-60
If, within the period, you have taken a Z1 Report at a workstation other than
the System Master, that workstation may have some of your period totals.
CASH 2
Your screen lists the first set of reports. You can press Cursor Up to display
more reports, if necessary. The following reports are available.
Report Numbers
7 Product Mix
8 From-To PLU
9 Each Cashier
12 Food Cost
13 Inventory
17 All Servers
[ report # ]
CASH
CASH
18 Each Server
22 Major Groups
23 Summary Groups
96-99 Tandem
CASH
Panasonic 5000 Version 3.0 Operating Instructions - Rev. 2.0
1 CASH
Reports