System Open (Report 200) - Panasonic 5000 Series Operating Instructions Manual

MANAGER OPERATIONS

System Open (Report 200)

After you take a System Close Report, the totals in your Basic workstations are reset and
then stored in the System Master. When you are ready to reset the System Master, use
the following procedure for System Open. You cannot perform System Open until you
have taken a System Close.
1. Turn the keylock at your System Master to MGR Mode.
2. Use the following sequence to begin System Open. The system checks to make sure
all workstation terminals are communicating.
2
3. If no errors are detected, go to Step 4. If an error exists, you see the Terminal
Status screen.
If one of your workstations is not communicating, a workstation number
displays beside the "ERR" message. Press CASH to escape from this menu.
Go to the workstation listed beside the ERR message and check to make
sure it is not in the middle of a transaction. Also check the cables. If you
locate and correct the problem, you can take another System Close to make
sure all of your totals are reported.
If you could not find a problem, go back to the System Master and follow
Steps 1 and 2, above. You may, at this point, want to call your Panasonic
representative before you proceed. To proceed, follow steps 3a, 3b, or 3c (on
the next page).
4-70
CASH
** TERMINAL STATUS **
BEGN #NN - END #NN
ERR: #NN
RETRY:
CONTINUE: 2 CASH
ESCAPE:
2 0
1 CASH
CASH
Panasonic 5000 Version 3.0 Operating Instructions - Rev. 2.0
Reports
0 CASH