Program 60: Downline Programming; Downlining To All Workstations - Panasonic 5000 Series Operating Instructions Manual

MANAGER PROGRAMS

Program 60: Downline Programming

When you change any of the files in your workstation, you can use the Downline Program
to send the changes to all other workstations on your system. The explanations for this
program are divided into three sections: Downlining to All Workstations, Downlining to a
Single Workstation, and Downlining the PLU file. Refer to the procedure you need.
All of the Downlining procedures reference the Downline File numbers listed below.
0 Date & Time
1 Subgroups
2 All PLUs
3 Cashiers
4 Product Mix
5 Messages & Prompts
9 Coupons

Downlining to All Workstations

In most instances, after you change your program you must send the changes to all
workstations. Use the following procedure to downline (send) your files system-wide.
Note: Do not use the following procedure to downline your PLU file without first reading
the warnings for PLU file downlining.
1. With your keylock in MGR Mode, use this sequence to advance to the Downline
program. Your system displays the Downline menu, shown on the next page. This
menu consists of more than one page. You can use the Cursor Up ( ) and Cursor
Down ( ) keys to move up and down in the Downline menu.
5
5-78
Downline File Numbers
CASH 6
14 Tare Weights
16 Major Groups
20 KPS Standard Menu
21 Master Files
30 Servers
0
Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
Downline Programming
CASH