All Void/Cancel; Delete - Panasonic 5000 Series Operating Instructions Manual

Error Correction
RES
Use the cursor keys ( , ) to place the cursor ( ) beside the item you want to void. Press
the VOID key. These steps void the Rare NY Strip from the example shown here.
Note: If you position the cursor beside the preparation instruction ("Rare"), the system
displays an error message when you press VOID. You cannot void a preparation
separately. It must be voided along with the item.

All Void/Cancel

The All Void procedure cancels all items and information you have entered within a
transaction. This procedure may be programmed to require a manager.
To cancel your current transaction press ALL VOID or CANCEL.
Note: In a check tracking system, you can use All Void to escape from a guest check. If, for
example, you enter items on the wrong check, you can press ALL VOID to escape and
start over. All Void cancels the last entries, so you can re-enter them on the correct
guest check.

Delete

Delete allows you to void an item after the transaction is paid. When you press DELETE,
your workstation is placed in a "void" mode. Everything entered after this point, and until
you pay the transaction, is subtracted from the totals. Your DELETE key may prompt you
to enter the time the error occurred. This entry helps adjust the time totals for a more
accurate account of daily activity.
Deletions are not allowed within a guest check transaction. Use the following procedure in
a cash (non-guest check) transaction only.
Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
VOID
ALL
VOID
OPERATOR PROCEDU
2-25