--------------------------------------------------------------------------------
XGE1/0/1
XGE1/0/2
XGE1/0/3
Remote:
Actor
--------------------------------------------------------------------------------
XGE1/0/1
XGE1/0/2
XGE1/0/3
The output shows that:
Link aggregation group 1 is a Layer 2 dynamic aggregation group.
•
The aggregation group contains three Selected ports.
•
Layer 2 aggregation load sharing configuration example
Network requirements
On the network shown in
Configure Layer 2 static aggregation groups 1 and 2 on Device A and Device B, respectively.
•
Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end.
•
Enable VLAN 20 at one end the aggregate link to communicate with VLAN 20 at the other end.
•
Configure link aggregation groups 1 and 2 to load share traffic across aggregation group member
•
ports:
Configure link aggregation group 1 to load share packets based on source MAC addresses.
Configure link aggregation group 2 to load share packets based on destination MAC
addresses.
Figure 14 Network diagram
Configuration procedure
1.
Configure Device A:
# Create VLAN 10, and assign the port Ten-GigabitEthernet 1/0/5 to VLAN 10.
<DeviceA> system-view
S
32768
S
32768
S
32768
Partner Priority Oper-Key
1
32768
2
32768
3
32768
Figure
14, perform the following tasks:
1
{ACDEF}
1
{ACDEF}
1
{ACDEF}
SystemID
1
0x8000, 000f-e267-57ad {ACDEF}
1
0x8000, 000f-e267-57ad {ACDEF}
1
0x8000, 000f-e267-57ad {ACDEF}
58
Flag