Port-Based Vlan Configuration Example; Network Requirements; Configuration Procedure - HP FlexFabric 12900 Series Configuration Manual

Port-based VLAN configuration example

Network requirements

As shown in
Host A and Host C belong to Department A. VLAN 100 is assigned to Department A.
•
Host B and Host D belong to Department B. VLAN 200 is assigned to Department B.
•
Configure port-based VLANs so that only hosts in the same department can communicate with each
other.
Figure 36 Network diagram

Configuration procedure

1. Configure Device A:
# Create VLAN 100, and assign Ten-GigabitEthernet 1/0/1 to VLAN 100.
<DeviceA> system-view
[DeviceA] vlan 100
[DeviceA-vlan100] port ten-gigabitethernet 1/0/1
[DeviceA-vlan100] quit
# Create VLAN 200, and assign Ten-GigabitEthernet 1/0/2 to VLAN 200.
[DeviceA] vlan 200
[DeviceA-vlan200] port ten-gigabitethernet 1/0/2
[DeviceA-vlan200] quit
# Configure Ten-GigabitEthernet 1/0/3 as a trunk port, and assign it to VLANs 100 and 200.
[DeviceA] interface ten-gigabitethernet 1/0/3
[DeviceA-Ten-GigabitEthernet1/0/3] port link-type trunk
[DeviceA-Ten-GigabitEthernet1/0/3] port trunk permit vlan 100 200
Please wait... Done.
2. Configure Device B in the same way Device A is configured. (Details not shown.)
3. Configure hosts:
Configure Host A and Host C to be on the same IP subnet. For example, 192.168.100.0/24.
Configure Host B and Host D to be on the same IP subnet. For example, 192.168.200.0/24.
Figure 36:
132