Accumetrics VerifyNow User Manual page 82

Press the Maintenance
2.
Press the Parameter
3.
the Appendix for information on navigating within the Maintenance section.
Figure 8-9 Network Setting
Network Setting
Press the Tab key 9 times to advance the cursor to the Network setting. At the
4.
Network prompt, press either the (← ← ← ← ) or (→ → → → ) key to change the setting between
NONE and a specific baud rate. If configuring a network, change the setting to
the rate that matches the capabilities of the network being used.
Press the Save
5.
menu. Press the Back
the changes.
In order to activate the saved baud rate, turn the VerifyNow instrument off and
6.
then on again.
NOTE: Unless a Network connection has been established, the network setting
should always be set to NONE.
VerifyNow System User Manual
key.
key to display the network setting (Figure 8-9). Refer to
key to keep the new setting and return to the Maintenance
key twice to return to the Main Menu without saving
Page 82
INSTRUMENT SETTINGS - 8
Save Setting
Back
14340.J