Set Time Out - Accumetrics VerifyNow User Manual

the instrument time setting. The hour value should be between 0 and 23. The
minute value should be between 0 and 59.
Record the new date stamp. Press the Tab key to move between the settings.
6.
The year value consists of four characters and must be 1999 or later. Use either
arrow key (← ← ← ← ,→ → → → ) to scroll through the months when setting the date. The day
value should be greater than 0, but not greater than the number of days in the
given month.
Press the Save
7.
menu. Press the Back
saving the changes.
NOTE: In the event a setting value is not within an expected range, an error
message will display after the Save
correct the mistake, then press the Save
Whenever an adjustment is made to the date or time setting, the instrument will
8.
require an EQC be performed.
8.4

Set Time Out

The VerifyNow Instrument has been designed with features that restrict instrument
access after a specified time period. If the instrument is idle for a longer period, the
display screen will go blank. When an operator presses a key, the instrument
automatically returns to the Main Menu and requires user login, if applicable. This
time period can vary based on the operation being performed and can be adjusted by
the user. It does not affect the display of assay results, QC results, or calculations.
Use the following procedure to adjust the setting:
From the main menu, enter
1.
the keypad to enter the Operator ID number at the prompt. Press the Tab key to
advance to the Password prompt to enter the password number.
Press the Maintenance
2.
Press the Parameter
3.
the Appendix for information on navigating within the Maintenance section.
VerifyNow System User Manual
key to keep the new setting and return to the Maintenance
key three times to return to the Main Menu without
key is pressed. Return to the setting and
Operator ID and
key.
key to display the time out setting (Figure 8-4). Refer to
Page 74
INSTRUMENT SETTINGS - 8
key again.
Password, if required. Use
14340.J