Table of Contents
Advertisement
5 Configuration
VLAN > GVRP > GVRP Global Settings
The GVRP Global Settings page allows user to configure the GARP timer values for application join, leave,
and leave_all GARP timer values.
GVRP: Disabled or Enabled the GVRP status.
Join Time (100-100000): Indicates the time in milliseconds that PDUs are transmitted. The default value is
200ms.
Leave Time (100-100000): Indicates the amount of time in milliseconds that the device waits before leaving
its GARP state. The leave time is activated by a leave all time message sent/received, and cancelled by the
Join message. The default value is 600ms.
Leave_All Time (100-100000): Used to confirm the port within the VLAN. The time in milliseconds between
messages sent. The default value is 10000ms.
Click Apply to implement changes made.
VLAN > GVRP > GVRP Port Settings
The GVRP Port Settings page allows user to determine whether the Switch will share its VLAN configuration
information with other GARP VLAN Registration Protocol (GVRP) enabled switches. In addition, Ingress
Checking can be used to limit traffic by filtering incoming packets whose PVID does not match the PVID of
the port. Results can be seen in the table under the configuration settings, as seen below.
Figure 5.31 – VLAN > GVRP > GVRP Global Settings
NOTE: Leave time must be greater than or equal
to three times the join time.
Leave_all time must be greater than the
leave time.
Figure 5.32 – VLAN > GVRP > GVRP Port Settings
34
D-Link Web Smart Switch User Manual
Hide quick links:
Advertisement
Table of Contents
