Remote Phone Settings - GE Advent Installation Instructions Manual

Local Phone Answer Time
17029
(Default = 8 seconds) Specify the maximum time (in seconds)
between a ring signal and local phone off-hook signal to be
considered answer of call.
Setting the Local Phone Answer Time:
Once the item number has been entered, enter the answer time
ƒ
(0–255). Press to apply the new setting.
On Hook Hang Up Time
17027
Default = 4 seconds) Select the amount of time (in seconds) a
local telephone must be on-hook before hanging up.
Setting the On Hook Hang Up Time:
Once the item number has been entered, enter the hang up time
ƒ
(2–10). Press to apply the new setting.
Enable Local Phone Police Alarm
Enable Local Phone Auxiliary Alarm
Enable Local Phone Fire Alarm
Police: 17080, Auxiliary: 17081,
Fire: 17082
(Default = off) Select whether or not you want to enable the
selected phone alarm sequence. If on, users will be able to
activate the specific alarm using a local phone (88888 for police,
77777 for auxiliary/medical, and 99999 for fire).
To turn Enable Local Phone Alarm On/Off:
Once the desired item number has been entered, enter
0
this setting on, or to turn it off. Press
setting.

Remote Phone Settings

Remote phone settings allow you to choose how phones
located off premises (different line) interact with the panel.
Enable Remote Phone Access
17086
(Default = on)
This setting allows you to enable remote phone
access. If on, the panel may be controlled using remote off-site
phones.
Note
Turning this setting to "off" will prevent the panel from
receiving future downloader calls.
Note
For residential use only.
To turn Enable Remote Phone Access On/Off:
Once the item number has been entered, enter
0
setting on (enabled), or to turn it off. Press
setting.
34
(Phone Access)
(Phone Access)
(Phone Access)
1
to turn
ƒ
to apply the new
(Phone Access)
1
to turn this
ƒ
to apply the new
Enable Remote Phone Ring Count
17087
(Default = on) This setting allows you to tell the panel to count
remote phone rings so that it will pick up after a certain number of
rings. This setting only works if Remote Phone Access setting
(above) is set to "on".
Note
For residential use only.
To turn Enable Remote Phone Ring Count On/Off:
Once the item number has been entered, enter
0
setting on, or to turn it off. Press
Answer Phone after XX Rings
17052
(Default = 12 rings) Specify the number of rings after which the
panel will answer an incoming phone call. The Enable Remote
Phone Ring Count setting (17087) must be set to "on" for this
setting to work.
Note
For residential use only.
To set the number of Rings:
Once the item number has been entered, specify the maximum
number of rings (1–12). Press
Enable Toll Saver
17090
(Default = on) Choose whether or not to enable the panel to
answer a remote phone up to 4-rings earlier than normal if an
alarm condition or system trouble has occurred. Normal is
considered the value in Answer Phone after XX Rings setting
(17052). The Enable Remote Phone Ring Count setting (17087)
must be set to "on" for this setting to take effect.
Note
For residential use only.
To turn Toll Saver On/Off:
Once the item number has been entered, enter
0
setting on, or to turn it off. Press
(Phone Access)
1
to turn this
ƒ
to apply the new setting.
(Phone Access)
ƒ
to apply the new setting.
(Phone Access)
1
to turn this
ƒ
to apply the new setting.
Advent Commercial Fire System