California State Fire Marshall Listed Installations; Planning The Installation; Panel Types; Panel Components - GE Advent Installation Instructions Manual

Table 5. UL 1023 Listed System Settings
Feature No. Feature
47004 Zone Attributes (edit sensors) N/A
xx = Two digit partition number.
yy = Two digit non-pager phone number.
Central Station Burglar-Alarm System Units (UL 1610)
System Setup and Programming
The system Feature Numbers shall be set as follows in
UL 1610 listed systems:
Table 6. UL 1610 Listed System Settings
Feature No. Feature
xx002 Siren Time Out
xx003 Standard Entry Delay
xx004 Exit Delay
yy004 Communication Format
xx088 Report Partition/Area Events
to Central Station
xx092 Enable Auto Force Arming
xx097 Exterior Arming Verification 0-Off
xx098 Audible Verification at Close
Report
xx102 One-Time Reset Enabled
xx108 Enable Daily Reporting of
Partition Trouble
17034 Phone Test Interval
17036 AC Stable Time
17041 Hours to Delay Before
Reporting AC Failure
17049 RF Supervisory Time A
17069 No Phone Line Attached
17072 Enable RF Jam Detect
17073 Battery Test Interval
17076 Commercial or Residential
Installation
17078 Detect Receiver Failure
17079 Alarm Messages Play at High
Volume
17096 Report System Events
47004 Zone Attributes (edit zones)
xx = Two digit partition number.
yy = Two digit non-pager phone number.
Digital Alarm Communicator System Units (UL 1635)
Same as UL 1610 plus:
‰ A UL Listed Exterior Siren
Central Station Reporting
The panel has been tested with the following central station
receivers using Contact ID reporting format:
4
‰ ITI CS-5000 Central Station Receiver
‰ Sur-Gard Central Station Receiver with models
Required Setting
CSA Certified Accessories
California State Fire Marshall Listed
Installations
The California State Fire Marshall listing has been
approved.
‰ ZONE ATTRIBUTES attribute 4 must be set to off
Required Setting

Planning the Installation

16 min., minimum
This section describes system capabilities to help you get
45 sec., maximum
familiar with the system. "Appendix A" provides planning
sheets with tables that let you record the hardware and pro-
60 sec., maximum
gramming configuration of the system. Fill in all necessary
0 Contact ID
information ahead of time to help prepare for the installa-
tion, and retain for your records.
1-On
0-Off
1-On
0-Off
1-On

Panel Types

To start planing the installation, find your specific panel
1 Day
type below. The panel type will help determine the system
capabilities (dependent upon devices used).
90 sec. maximum
6-12 hours
4 hours
0-Off
Part Number
1-On
1-4 hours
1-Commercial
250Z, 60-562-03
1-On
132Z, 60-562-06
1-On High
1-On

Panel Components

N/A
Before installing devices and making wiring connections,
familiarize yourself with the main panel components. Fig-
ure 1 shows the main component locations for the circuit
board.
SG-DRL2A and SG-CPM2
(47004)
Note
It is recommended that no more than 250 wireless fire
sensors (60-849-01-95 or 60-917-95 only) and a maxi-
mum of 132 of all other wireless sensors be used on 250
zone Advent systems.
If 2 Advent systems are in close proximity the total number
of wireless sensors for all systems must not exceed 250
wireless fire sensors or 132 of all other sensors.
Table 7. Advent Commercial Panel Types
Description
Commercial Fire
Panel. UL Listings
include 864, 365, 609,
985, 1023, 1610, and
1635. Red enclosure.
8 250 250 512
4 100 132 256
Advent Commercial Fire System