GE Advent Installation Instructions Manual page 43

Bus Device Partition/Area
48004
(Default = n/a) Use this item number to assign bus devices to
partitions/areas.
Note
All bus devices default to partition/area 1.
To assign Bus Devices to Partition/Area:
1. Once in program mode enter
shows ENTER DEVICE ID OR PRESS * TO CANCEL.
2. Enter the 8-digit device ID and press
shows ENTER PARTITION NUMBER OR PRESS * TO
CANCEL.
3. Enter the partition/area number and press
shows DEVICE xxxxxxxx IS IN PARTITION n.
Note
If the partition/area is not enabled, the display will show
PARTITION nn INVALID. See item number xx068
(page 17) to enable partition/area(s).
Change Transmit Bus ID
48005
(Default n/a) This item number allows you to change or view the
wireless transmitting device ID used to communicate with
"buddy" panels and/or wireless 2-way devices.
To change/view Transmit Bus ID:
1. Once in program mode enter
shows RADIO ID IS xxxxxxxx, then displays ENTER
NEW TRANSMIT ID OR PRESS # TO ACCEPT.
2. Enter the new 8-digit transmit ID or press
existing ID. The touchpad displays RADIO ID IS
xxxxxxxx.
List Bus Device Text
48006
(Default = n/a) Use this item number to list existing bus device ID
numbers and display text.
To List Bus Device Text:
Once in program mode enter
ID xxxxxxxx any device text.
The panel will scroll through and display information about each
device. To skip forward press
lists all the bus devices it will return to the program menu.
Advent Commercial Fire System
(Accessory)
48004 . The display
ƒ . The display
ƒ . The display
(Accessory)
48005 . The display
ƒ to accept the
(Accessory)
48006
. The display will show
ƒ ‚
. To exit press . Once the panel
Replace/Delete Bus Device ID
48007
(Default = n/a) Changes (overwrites) the bus device text with that
of another bus device.
To Replace/Delete Bus Device ID:
1. Once in program mode enter
shows ENTER DEVICE ID OR PRESS * TO CANCEL.
Note
If the display shows DEVICE xxxxxxxx INVALID, there is
no device text associated with the device ID you entered.
2. Enter the 8-digit device ID of the device you wish to
replace/delete (located on module) and press
3. The display shows ENTER NEW DEVICE ID OR ENTER
0 TO DELETE.
4. Enter the new device ID or enter
Program LED Module
48009
(Default n/a) Use this item number to program LED modules
(driver boards).
To program LED Modules:
1. Once in program mode enter
shows ENTER DEVICE ID OR PRESS * TO CANCEL.
2. Enter the 8-digit device ID number and press
play shows ENTER LED NUMBER OR PRESS * TO
CANCEL.
3. Enter the desired LED number (0–128) and press
display shows LED TYPE IS n. ENTER NEW LED TYPE
OR PRESS # TO ACCEPT.
4. Enter the desired LED type (0–15) from Table B.10 on
ƒ . The display shows LED DATA IS
page 106 and press
n. ENTER NEW LED DATA OR PRESS # TO ACCEPT.
5. Depending on the LED type, enter the desired LED data
(see Table B.10) and press
6. To program another LED group, go back to step 1. To exit
back to the program menu, press
(Accessory)
48007 . The display
ƒ .
0 . Press ƒ .
(Programmable Output)
48009 . The display
ƒ . The dis-
ƒ . The
ƒ .
‚ .
41