Parameter Tables - Omron R88M-W User Manual

Operation
Example of an n. + 4 Digits Parameter Setting
PR02W Front panel
operation key operation
(less than
1 s)
Saving the Changed Setting to Memory
• The following operation is not necessary if you are only checking the settings.
PR02W Front panel
operation key operation
(1 s min.)
(After approx. 1 s)
D Return to Parameter Number Display
PR02W Front panel
operation key operation
(1 s min.)

4-4-2 Parameter Tables

• Some parameters are enabled by turning OFF the Unit, then turning it ON again. (See the tables be-
low.) When changing these parameters, turn OFF the power (check that the power lamp is not lit), then
turn ON the power again.
• The specific digit number of a parameter for which each digit number must be set separately is dis-
played in the table with ".0" added to the digit number. For example, Pn001.0 (i.e., digit No. 0 of param-
eter No. Pn001).
• The default setting for parameters set using 5 digits are displayed in the table with the leftmost digits
not shown if they are 0 (e.g., if the default setting is 00080, 80 is entered in the table).
• Do not set parameters or digit numbers shown as "Not used."
• Parameters marked with one asterisk are for the DeviceNet Option Unit. Do not change the settings of
these parameters unless a DeviceNet Option Unit is mounted.
• Parameters marked with two asterisks are supported by Servo Drivers with software version "r.0037."
4-18
Display example
(Present setting)
Digit No. 3 Digit No. 0 Set the digit No. to be operated using the Left Key (front
panel: DATA Key for less than 1 s) or Right Key. You
cannot use only the Up and Down Keys.
Display example
Press the DATA Key (front panel: DATA Key for 1 s min.)
to save the data to memory (the setting display will flash
for approximately 1 s).
After the display has finished flashing, it will return to
normal.
Display example
Press the DATA Key (front panel: DATA Key for 1 s min.)
to return to the parameter No. display.
Chapter 4
Explanation
Explanation
Explanation