Omron R88M-W User Manual page 229

System Design and Installation
H
R88D-WT05H/-WT08H/-WT10H/-WT15H/-WT20H/-WT30H/-WT50H/-WT60H/-WT75H/
-WT150H
Class-3 ground
(See note 4.)
DC Reactor
24 V DC
User-
controlled
device
Control cable
3-16
Three-phase 200/230 V AC 50/60 Hz
Noise filter (See note 2.)
Main-circuit power supply
Surge killer (See note 2.)
OMNUC W-series
AC Servo Driver
24 V DC
Class-3 ground
(See note 3.)
(See note 1.)
Note 1. Set by user parameter Pn50F.
Main-circuit connector (See note 2.)
Servo error display
OMNUC W-series
AC Servomotor
Power Cable
(See note 5.)
Encoder Cable
24 V DC
2. Recommended product in 3-2-4 Wiring for Noise
Resistance. For conformity to EC Directives, refer to
3-2-5 Wiring for Conformity to EMC Directives.
3. Recommended relay: MY relay (24 V), by OMRON.
For example, an MY2 Relay outputs to a 2-A
inductive load at 24 V DC, making it applicable to all
W-series Motors with Brakes.
4. Refer to 6-3 Single-phase Power for 3,000-r/min
(750-W) Servomotors when using an R88D-WT08H
with single-phase 200-V power supply.
5. The brake is not affected by the polarity of the
power supply.
Chapter 3