Shifting Of Softkey Positions For Busy States - Aastra 6730i Administrator's Manual

Operational Features
Notes:
• The "collapsed softkey screen" parameter applies to both top and bottom softkeys and is enabled by default.
• When the "collapsed softkey screen" parameter is disabled, bottom softkeys configured with a function that is to be
displayed only in specific states will be displayed as a blank softkey in all other states. For example, if a bottom softkey
is configured with speed dial functionality in the connected, incoming, outgoing, and busy states, when the phone is
idle, the softkey will be blank (i.e. no label is displayed) and will not be functional.
Configuring Programmed Softkey Positioning Options
Use the following procedures to configure the programmed softkey positioning options.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
page A-165.

Shifting of Softkey Positions for Busy States

Note:
Applicable to the 6735i, 6737i, 6755i, 6757i, 6757iCT, 9480i, 9480iCT, and 6867i IP Phones only.
By default, user configured softkeys are automatically shifted from the first page of softkeys to the second page when
the phone is in a busy state. Administrators have the option of "collapsing" the user configured softkeys to start on the
first available softkey position after the context-sensitive softkeys during the following busy states:
• outgoing
• ringing
• connected
• hold
This feature is configured by defining the "collapsed context user softkey screen" parameter as "0" (disabled) or "1"
(enabled) in the configuration files.
Note:
The "collapsed context user softkey screen" parameter is disabled by default.
For Example:
During a call on a 6755i IP phone with the "collapsed context user softkey screen" parameter disabled and with
softkey 1 configured as Park and softkey 2 configured as DND, these two softkeys will not appear on page 1. The user has
to press the More key to access them on page 2.
During a call on a 6755i IP phone with the "collapsed context user softkey screen" parameter enabled Park and DND
appear on page 1 in softkey positions 4 and 5 (Drop, Conf, and Xfer situated in softkey positions 1, 2, and 3).
Configuring Collapsed Context User Softkey Screen
Use the following procedures to configure the collapsed context user softkey screen.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
page A-165.
5-117
"Configurable Positioning of Programmed Softkeys"
"Configurable Positioning of Programmed Softkeys"
41-001343-02 REV05 – 07.2014
on
on