Aastra 6730i Administrator's Manual page 503

$$LINESTATE$$ Value
CONNECTED
CLEARING
The Action URI Disconnect feature allows an Administrator to determine the reason for the disconnect if required.
Note:
If you enable the Action URI Disconnect feature by specifying a URI, the URI is called when any disconnect event occurs
including an intercom call or a conference setup.
Example
If you enter the following string on Phone A for the "action uri disconnected" parameter:
action uri disconnected: http://fargo.ana.aastra.com/disconnected.xml?state=$$LINESTATE$$
and then Phone A calls Phone B, Phone B answers and then hangs up, Phone A executes a GET on:
http://fargo.ana.aastra.com/disconnected.xml?state=CONNECTED
which is what the remote server receives.
Note:
If the phone can't find the Action URI you specify, it returns a "NULL" response. For example,
http://fargo.ana.aastra.com/disconnected.xml?state=
An Administrator can enable the disconnect feature using the configuration files or the Aastra Web UI.
Configuring the Action URI Disconnected Feature
Use the following procedure to configure the Action URI Disconnected feature on the phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
41-001343-02 REV05 – 07.2014
Description
Parties are talking.
Call was released but not acknowledged.
Operational Features
Meaning in a Disconnected URI
Call was successful.
N/A
"Action URI Settings" on page A-116.
5-262