Aastra 6730i Administrator's Manual page 861

# NAT Settings
# = = = = = = =
# Option 2:
#
# If you are using a session border controller, you should set the
# outbound proxy to the session border controller address
#sip outbound proxy: sbc.aastra.com
#sip outbound proxy port: 0
# Option 3:
#
# If you know the public IP address of your NAT device and have
# opened up a port for the SIP messages then you can statically
# assign this information.
#sip nat ip: 67.123.122.90
#sip nat port: 5890
# Additional Network Settings
# ============================
#sip rtp port: 3000
#-----------------------------------------------------------------
# Configuration Server Settings
# = = = = = = = = = = = = = =
# Notes: This section defines which server the phone retrieves new
# firmware images and configuration files from.
# are supported TFTP, FTP and HTTP
download protocol: TFTP
## TFTP server settings
tftp server: 192.168.0.130
#alternate tftp server:
#use alternate tftp server: 1 # If your DHCP server assigns
# a TFTP server address which
# you do not use, you can use
# the alternate tftp server.
## FTP server settings
#ftp server: 192.168.0.131
#ftp username: aastra
#ftp password: 6757iaastra
## HTTP server settings (for http://bogus.aastra.com/firmware/)
#http server: bogus.aastra.com
#http path: firmware
#----------------------------------------------------------------
41-001343-02 REV05 – 07.2014
# a value of 0 enables SRV
# lookups for the address of
# the proxy.
# Eg. RTP packets are sent to port 3000.
Three protocols
# valid values are TFTP, FTP and HTTP
# can be IP or FQDN
# can be IP or FQDN
Sample Configuration Files
C-22