Recommended Test Equipment - Ametek UPLC-II System Manual

Recommended Test Equipment

Table 4–1 shows the equipment used to test, service and verify your UPLC-II™ unit.
High-Impedance Frequency Selective Level Meter
1 kHz to 1 MHz
• PowerComm Solutions PCA-4125
• Signal Crafters Model 110
• Spectrum Analyzer
Reflected Power Meter
• Signal Crafters Model 70
• PowerComm Solutions PCA-4125
Signal Generator
• Signal Crafters Model 90 or 110
• PowerComm Solutions PCA-4125
Non-Inductive Resistor, 50 or 75Ω, 25Ω
• Opek DL-60: 50Ω, 20W Load
• DX Engineering DL30A: 50Ω, 15W Load
Loads Also Included in the Following Equipment
• PowerComm Solutions PCA-4125:
50Ω, 18W Input
• PowerComm Solutions Model 630:
50Ω, 25W Load
• Signal Crafters Model 70:
50Ω, 50W Load
We recommend that the user of this equipment become thoroughly acquainted with the information in
these instructions before energizing the UPLC-II™ and associated assemblies. You should not remove or
insert printed circuit modules while the UPLC-II™ is energized
ules are sensitive to and can be damaged by the discharge of static electricity. You should always observe
electrostatic discharge precautions when handling modules or individual components. Failure to observe
these precautions can result in component damage.
requires a UhF Female to BnC Female adapter to interface Directly to the UPlC-ii
1
except for Power amp and Power Supply modules.
2
Copyright © ameTeK
4. Test Equipment
Table 4–1. Recommended Test Equipment
Equipment
1
1
CAUTION
!
Application
Checking TX/RX Levels
Checking Noise Levels
Adjusting Line Tuner to Match
™
UPLC-II Output Impedance
For Setting RX Sensitivity when
no Remote TX is Available
Transmitter Termination
(For Calibration)
. All integrated circuits used on the mod-
2
™
.
4
Page 4–1