Ametek UPLC-II System Manual page 118

UPlC-ii™ System manual
Input Name
Trip Key
UB Key
DTT Key
LR Key
A Key
B Key
PC Key
Power Off
Boost TX
Trip Test Inputs
SOE Event 1/2/3
Output Name
General Alarm
Reflected Power
Main RF Output
Redundant RF Output
TX Shift High
TX Shift Low
Fade Alarm
Good Channel
Noise
Guard
Trip
Checkback Trip
DTT Guard
DTT Trip
DTT Checkback Trip
LR Guard
LR Trip
LR Checkback
Trip Negative
Trip Positive
A or B Guard
A or B Trip
A or B Checkback Trip
Trip Test Outputs
Page 5–26
Table 5–14. (FSK Mode) Input/Output Descriptions
TX or
RX
TX TX keyed to Trip Frequency
TX TX keyed to Unblock Trip Frequency
TX TX keyed to Direct Transfer Trip Frequency
TX TX keyed to Line Relay (POTT/UB) Trip Freq.
TX TX keyed to Channel "A" Trip Frequency
TX TX keyed to Channel "B" Trip Frequency
TX TX keyed for Phase Comparison
TX TX output level shut off, no frequencies transmitted
TX TX output level increased to high level setting in Phase Comparison mode
TX See Chapter 6
Both Causes "Event 1/2/3" to be recorded in SOE log
TX or RX
Both Any major hardware failure occur
TX TX % reflected power above threshold setting
TX TX level above 0.3W on Main Power Amp
TX TX level above 0.3W on Redundant Power Amp
TX TX keyed to shift high frequency
TX TX keyed to shift low frequency
RX RX level below fade alarm threshold setting since last RX calibration
RX RX level below fade margin threshold setting since last RX calibration
RX RX freq. not recognized, unstable in freq. or high noise relative to valid signal
RX Receive Guard Freq. with adequate level & RX logic satisfied
RX Receive Trip Frequency with adequate level & RX logic satisfied
Receive Trip Frequency with adequate level only (Do not have to receive
RX
Guard before Trip)
RX Receive DTT Guard Frequency with adequate level & RX logic satisfied
RX Receive DTT Trip Frequency with adequate level & RX logic satisfied
Receive DTT Trip Frequency with adequate level only (Guard before Trip not
RX
required)
RX 3-Freq Receive Line Relay (POTT/UB) Guard Frequency & RX logic satisfied
RX 3-Freq Receive Line Relay (POTT/UB) Trip Freq. & RX logic satisfied
3-Freq Receive Line Relay (POTT/UB)Trip Freq. with adequate level only
RX
(Do not have to receive Guard before Trip)
RX Phase comparison negative half cycle frequency received
RX Phase comparison positive half cycle frequency received
RX 4-Freq Receive A or B Guard Freq. with adequate level & RX logic satisfied
RX 4-Freq Receive A or B Trip Freq. with adequate level & RX logic satisfied
4-Freq Receive A or B Trip Freq. with adequate level only (Do not have to
RX
receive Guard before Trip)
Both See Chapter 6
Action When Input Applied
Active State