Boosters In Parallel - Checkout Test; Key Specifications - Ametek PMC BOOSTER Series Hardware Manual

Boosters in Parallel – CheckOut Test
They following test was ran with the 0.01 Ohm resistor as before. Because of this, only 20 mV needs to
be applied to generate 20 Amps of current.

KEY SPECIFICATIONS

Highest Current Range
Compliance Voltage
EIS Bandwidth
Data Acquisition Rate
Connectivity
Field Upgradeable
PMC BOOSTER5A
+/- 5 A
-1 V to + 6 V
300 kHz
Defined by Potentiostat
PMC-2000 is 1000 kS/sec (1 µs)
PMC-1000 is 500 kS/sec ( 2 µs)
Installs into 2-slots of the PMC
CHS08A chassis
Yes
PMC BOOSTER10A
+/- 10 A
-1 V to + 6 V
300 kHz
Defined by Potentiostat
PMC-2000 is 1000 kS/sec (1 µs)
PMC-1000 is 500 kS/sec ( 2 µs
Installs into 2-slots of the PMC
CHS08A chassis
Yes