Fsk Mode Alarms - Ametek UPLC-II System Manual

3.9 FSK Mode Alarms

The following tables show alarms for FSK mode.
Hardware Fixed Alarm (from Power Supply Board)
Hardware Failure Alarm for All UPLC-II™ Units
Alarm Reason:
Alarm Name:
(Available Outputs)
Contact Type:
UPLC-II™ Condition
PS Good
PS Bad
**For the Redundant Power Supply, use TB2-5 & 6
Software Programmable Alarms/(Outputs from I/O Board)
Hardware Failure Alarm for All UPLC-II™ Units
Alarm Reason:
Alarm Name:
(Available Outputs)
Contact Type:
UPLC-II™ Condition
All OK
Hardware Failure
Loss of DC Power
January 2016
Table 3–6.
All Modes
One of the PS outputs is too low in voltage
Power Supply Alarm Output
(TB1-5 & 6)**
De-Energized State
N.O. Contact N.C. Contact
Closed
Open
Table 3–7.
FSK Mode
Hardware health of at least one card is bad
General Alarm Output
(LL08 – LL10)
De-Energized State
N.O. Contact N.C. Contact
Closed
Open
Open
Chapter 3. applications
Open
Closed
Open
Closed
Closed
Page 3–37
3