Ametek UPLC-II System Manual page 177

1 - PULSED (on for 5 sec.)
NOTE: General Alarm is a valid option only for the
EM Outputs.
De-Energized State
<em1_selection>1</em1_selection>
De-energized State is a single digit value:
0 – Normally Open
1 – Normally Closed
Checkback Configuration
Module Address
<address>0</address>
Module Address is a number between 0 and 10. 0
being the Master and 1-10 are Remote Modules
Primary Communication Mode
<prim_comm>1</prim_comm>
Primary Communication mode is a single digit
value. Only 0 or 1 is valid:
1 – Coded Communication Mode
0 – Timed Communication Mode
Auto Tests
<auto_test>1</auto_test>
Auto tests is a single digit value. Only 0 or 1 is
valid:
1 – Auto Tests On
0 – Auto Tests Off
Fallback Communication Mode
<fallback>0</fallback>
Fallback Communication Mode is a single digit
value. Only 0 or 1 is valid:
1 – Enable Fall back Communication
0 – Disable Fall back Communication
Low Power Tests
<low_pwr>0</low_pwr>
Low Power Tests is a single digit value. Only 0 or 1
is valid:
1 – Enable Low Power Tests
0 – Disable Low Power Tests
January 2016
appendix C: Xml File Format
Last Module
<last_rem>1</last_rem>
Last Module is between 1 and 10; up to ten Remote
Modules can be assigned.
Retries
<retries>4</retries>
Retries is 0 – 15, indicating, up to 15 retries are
allowed.
Interval Type
<int_type>0</int_type>
Interval type is a single digit value. Only 0 or 1 is
valid:
1 – Checkback Hours of the day
0 – Periodic checkback select
Hours Of The Day
(Valid only when 'Hours of the Day' is selected)
<time1>5</time1>
<time2>10</time2>
<time3>15</time3>
<time4>20</time4>
Hours of the day 0 – 23 in a 24 hour clock format.
This indicates the hours of the day checkback needs
to run.
Periodic Checkback
(Valid only when 'Checkback Hours' is selected)
<test_period>8</test_period>
Periodic Checkback is 0 – 99. This indicates the
number of hours to wait before the next Checkback
test will run.
Carrier Recovery
<reco_enab>0</reco_enab>
Carrier Recovery is a single digit value. Only 0 or 1
is valid:
1 – Enable Carrier Recovery
0 – Disable Carrier Recovery
Recovery Window
<recovery_time>10</recovery_time>
C
Page C–7