Dnp Analog Inputs (Uplc-Ii™ Analog Values) - Ametek UPLC-II System Manual

7.4 DNP Analog Inputs (UPLC-II™ Analog Values)
The UPLC-II™ has 4 analog UPLC™ measured values that can be set to be read via DNP.
Point Name
0 TX Signal Level
1 RX Signal Level
2 RX Fade Margin
3 Percent Reflected Power
DNP Analog Inputs / UPLC-II™ Analog Values Settings Page
January 2016
Table 7–5.
UPLC-II™ Analog Values
(All Modes)
Definition
Measured Transmit Signal Level to Coax
Measured Receive Signal Level from Coax
Measured dB RX Margin – Amount Signal can Fade & Still Work
Measured % Reflected Power for TX
Figure 7–5.
(Admin > Protocol > DNP > UPLC-II™ Analog)
Chapter 7. Communication Protocols
7
Page 7–7