Test Button Menu - Ametek UPLC-II System Manual

1. Settings
ON/OFF Mode FSK Mode | 2F/4F
1. TX Freq. 1. TX Freq.
2. RX Freq. 2. RX Freq.
3. Bandwidth 3. RX Bandwidth
4. Level Display 4. RX Shift
dB or V/W 5. TX Bandwidth
6. TX Shift
7. Pre-Trip Delay
8. Level Display
dB or V/W
Figure 5–19. UPLC-II™ SET Button Menu (ON/OFF & FSK)

5.11.4 Test Button Menu

See Figs. 5–20, 21, 22. Pressing the TEST or Left arrow allows you to test the functionality of the unit. It
also shows the TX reflected power percentage on the top line above the TEST menu. This TEST menu can
be password-protected if desired (see Figure 5–3).
Refl Pwr: X% (TX Reflected Power is Displayed Only When Transmitting)
1.HL Send 2. LL Send 3. CB Initiate
(High (Low
Level TX) Level TX) CB Test)
CAUTION
!
Be sure all trip circuits are open
before toggling outputs in test menu.
Figure 5–20. UPLC-II™ TEST Button Menu (ON/OFF Mode Only)
January 2016
Chapter 5. installation/Commissioning Procedure
SET
Enter Password:
US1NEM9AFSX
FSK Mode | 3F
1. TX Freq.
2. RX Freq.
3. RX Bandwidth
4. RX Shift
5. TX Bandwidth
6. TX Shift
7. LR Pre-Trip Delay
8. DTT Pre-Trip Delay
9. Level Display
dB or V/W
TEST
* *
4. Loopback 5. Reset CB
(Start Initiate
(Turns On
Remote
Transmitter)
*
Only available with Checkback testing facilities option.
(11 Digit Catalog Number is Displayed)
2. Configure
1. Change Password
2. IP Address
(IP, Mask, Gateway)
3. View MAC Address
4. View Revisions
(firmware, Cat #)
* *
6. Reset CB
Alarms Recovery
(Clear CB (Clear CB
Alarms) Recovery
Mode)
1.Show Inputs
12345
Inputs:00000
(1=Volt Applied
0=No Volt Applied)
3. Calibrate
1. Transmitter
2. Receiver
a. RX to Distant TX
b. RX to Local TX
(ON/OFF mode only)
3. Adjust External CLI
7. Test I/O
(Test Inputs
& Outputs)
2. Change Outputs
Outputs
EM1234 LL1234567890
0000 0101010101
(1=Output Closed,
0=Output Open)
Page 5–37
5